Panchayati Raj Department- Secretary And Commissioner- Ceo- Bundi- Bdo- Talera - Agency Tenders

The tender is for hand pump or tubewell installation work at all gram panchayats of Panchayat Samiti Talera. The tender closing date is 09/09/2025 at 04:00 PM. The tender fee is INR 1,000. An EMD of INR 98,000 is required. The validity of the rate contract is up to one year after approval of rates. The work has to be accomplished within 7 days after issuing of work order. Separate work order will be issued for one or more units by different gram panchayats. The actual amount of executed work may vary as per requirement. The contractor will have to submit manufacturer's testing certificates of the items like pipe, HP set, etc. and a copy of challan from the manufacturer or authorized dealer. The contractor has to get approved the manufacturer brand of the material items from concerned A. En. The work will be allotted as per necessity. No conditional tenders will be accepted. Itemwise rates will not be considered. Rates only percentage above/below on complete schedule at prescribed place in tender document will have to be submitted by the contractor. Payment will be made by the executive agency after completion of individual borewell/tube well in all respects. Payment for dry point will be made to the contractor as per GKN 2025. The site location of drilling for installation of single phase shall be finalized in consultation with hydro geologist of PHED as per norms of the department and only at such selected site the work will be carried out by the contractor after its pinpointing by the site engineer. The bores should generally be drilled up to 100mm depth. Prior approval should be obtained from competent engineer, in case it is required to be drilled deeper. Guidelines issued by the technical committee vide T. C. no. 236 dated **** shall be followed. The casing pipe shall be embedded one meter deep in the rock formation below alluvial strata. However, minimum of 6 meters casing pipe shall be fixed by the contractor. A collar may be welded at the bottom of top casing pipe if required, so that the gap between casing pipe and sides of bore hole be filled up to 5 meters with betonite powder/clay slurry to prevent. After completion of the work, the bore will be handed over to the concerned GP. Please execute the agreement on non-judicial stamp paper of rupees **** with this office within 7 days.